Made from folded laser cut aluminium with swaged lightening/stiffening holes, held together with aluminium rivets.
These are made from 1.5mm thick sheet. We did offer a 1mm version but nobody bought them!
The seats can be made any width to suit your car or arse, whichever is the governing factor. Even a miss matched pair, no problem. The ones pictured are 18″ wide. Seat back is 600mm high & base is 380mm long.
A drain hole is now included in each rear corner of the base. Just in case your passenger wets themself.
It should be noted that the Aluminium is quite soft and, although there is some built in stiffness, they should be supported both underneath & across the back, by a bulkhead or roll cage member. you don’t want them splitting when you throw yourself into them, however pretty your headlining might be to look at.
Our seats are made by hand & in a hurry ( & occasionally under fire) for that authentic WW2 look, so they may need some polishing if you’re after a show finish as there will inevitably be scratches from the bending & folding processes.
Seats are made to order and would be best collected at shows or from our office in Derby, due to the easily damaged nature of the material & the fact that postage would be £30.
If you are ordering from overseas we can supply supply these flat pack, IKEA style for you to rivet together yourself, this saves considerably on the shipping costs (It’s a big box for 2 seats!). Please contact us for prices.
If ordering for collection at a show, please order at least 10 working days before the event.